Item # B-30-3-CS, 12982 Cubic Feet Per Minute (ft³/min) Capacity at 1/8 Inch (in) Static Pressure Belt Drive Model BCS Tube Axial Duct Fan On Indventech

Model BCS - Tube Axial Duct Fan - Belt Drive

Designed for use in high moisture or contaminated airstreams
Ideally suited for use on industrial parts washers for excess vapor removal
Standard construction suitable to 225°F and up to 375°F with high temperature package
Bearings located in sealed watertight chamber and protected by water slinger and shaft seal
Cast Al prop standard; CS and SS also available
Available in 304 or 316 SS for harsh or contaminated environments
Adjustable motor base for proper belt tension
TEFC or EXP motor
Cast iron or turned steel pulleys
Select options below for more information or request a quote

Unit of Measure

Specifications | Performance Data | Outstanding Features | Accessories and Options | Note

Power

N/A 3 hp

Fan Size	N/A 30 in
Fan Speed	N/A 1350 rpm
Number of Blades	N/A 6
Prop Number	N/A CA115
Free Air	N/A 13480
Capacity at 1/8 Inch (in) Static Pressure	N/A 12982 ft³/min
Capacity at 1/4 Inch (in) Static Pressure	N/A 12498 ft³/min
Capacity at 3/8 Inch (in) Static Pressure	N/A 12042 ft³/min
Capacity at 1/2 Inch (in) Static Pressure	N/A 11465 ft³/min
Capacity at 3/4 Inch (in) Static Pressure	N/A 10380 ft³/min
Capacity at 1 Inch (in) Static Pressure	N/A 9470 ft³/min
Capacity at 1 1/4 Inch (in) Static Pressure	N/A 7500 ft³/min

N/A

Sealed ball bearings with external grease fittings.
Fan can be installed in any position.
Propellers non-sparking cast aluminum
Fan housing is heavy gauge steel with angle iron rings welded on each end for superior strength.
Eight holes in angle rings for easy mounting.
Standard constructions 225 ºF. Temperatures up to 375 ºF with special construction.
Motors - only high quality industrial motors are used. Fans with motors are completely assembled, drives properly adjusted, and fan tested at the factory before shipping. Motors are available in open drip proof, totally enclosed, and explosion proof.
Cast steel and turned steel sheaves.
Adjustable motor base.
Bearings are located in the belt tube, removed from the contaminated airstream. Belt tube interior is protected from contaminated air in duct by water slinger, dust cover, and shaft seals.

N/A

Companion Flanges - For easy installation of duct fans.
Protective Coatings - Epoxy and Eisenheiss coatings provide good protection against most corrosive agents.
Variable Pitch Pulleys - Allow for moderate variation of fan speed for flexibility and system modification.
Access Doors - Hinged access doors, gasketed and latched, provide for periodic inspections.
Belt Guards - Adjustable, galvanized construction.
Motor Covers - Galvanized, designed to fit all belt drive tube axial duct fans. (Specify motor frame)

N/A Bearings must be protected by weather cover or other means from contaminated air, exterior to the fan, at installation.